Update

Hey folks, hope all is well out there. Here are the bits:

Frontend:

• Fixed:

  • Recipe cards were not going back to their original size after clicking out of an expanded/selected card.

  • Header breadcrumbs were breaking nav on click for views that were more than two levels deep.

  • Header status icons broke the header layout when more than one status sub-type’s update occurred at the same time.

• Improvements:

  • Updated the recipe card list component to dim all other cards when a card is selected.

  • There is a lot of additional meta-data about recipes, some of which will be displayed in the expanded card view. This isn’t vital to base functionality though, so I will be holding off on integrating it into the card view until we have finished all the other stuff.

Other Bits:

• I’m triple checking pin assignments and re-confirming all sensors/controls have a home in preparation for the next revision of the primary PCB. This should be completed tonight with the board going to fab tomorrow or Tuesday.

• Weight sensor PCB tracking info shows a delivery date of Tuesday. Once they get here I’ll assemble and test. This is expected to be a quick process.

• Once those are tested and installed I’ll be running through full brew cycle testing.

• Next weekend I will start prepping shipment notification emails and details for the orders going out in this first batch. I don’t think I will be sending these out until the following week though.

• I do not know when I will be back on Cloud Control, just been hyper locked in on frontend and hardware completions. Best estimate is after a chunk of the brew testing has been completed. I’ll have to test the remote brew control and integration set up, so it will be a good time to sign off on any remaining tasks. I’ll keep everyone posted on progress.

• Next update will be out on Tuesday or Wednesday and will just be focused on the weight sensor PCBs testing results.

Cheers!