Quick Demo

Hey folks, hope all is well out there. Been running through tests and recording some demos today. I have attached one here that did not go so well.

I noticed there was some pump resonance being transferred to the tubing due to how I had it clipped to the frame. I stopped the brew using a direct API call to Operator to rearrange the test rig a bit. Then, instead of restarting the current brew, I manually sent a call to a utility/testing endpoint that just runs the pump full speed until I send a stop command…🫠

There’s a small cut in the vid for brevity as it was recording while I moved the tubing and pump.

Here is how it went:

So, not super amazing but a good reminder to add the cone mech retention clip from the main enclosure to the test rig! I’m also going to update how the dev/test endpoints are accessed so they are not active when running full brew cycles. They’re great for testing specific functions while troubleshooting or coding, but a bit of a foot-gun if you’re testing real world usage.

I decided to call it a day after that but still have some more demos and updates to share. I will have another update out with them at some point tomorrow.

Cheers!